The Motobilt Jeep Wrangler JK Crusher recessed winch bumper will provide you the ultimate in protection and recovery. The bumper allows you to secure your winch down low in between the frame rails. The high clearance design includes a built in skid plate also. The bumper is made from 3/16 inch thick steel plate that is laser cut at Motobilt HQ then cnc bent. The bumper uses 3/4 inch thick laser cut d-ring mounts that pass through the bumper and are welded both inside and out. This setup provides for superior strength.
Features
Jeep Wrangler JK front Crusher recessed winch bumper
Measures in at just 46.5 inch at its widest point
3/16 inch thick steel plate
3/4 inch thick laser cut d-ring mounts that pass through the bumper and are welded both inside and out
Includes all the necessary mounting hardware
Sold as each
Note:
Will Not work with Teraflex S/T Dual rate front sway bar
The outer edge of the crash bar will need to be trimmed to fit where the lower portion of the bumper mounts
The 8 factory mounting holes may need to be open up to a 9/16".
Ships bare metal and will need to be painted or powdercoated once you receive it
You must fully install BEFORE painting and then removed for paint or powder coating.
2012 and newer models will need a vacuum relocation pump PN MB2060. The factory bracket must be cut off in order for the winch plate to fit.
Fairlead spacer included to allow use of a centered or off set winch design.
Does NOT work with Super Winch EXP
Specs:
Finish:
Bare
Hardware Included:
Yes
Location:
Front
Material:
Steel
Series:
Crusher
Sold As:
Each
Style:
Full Width
Thickness:
3/16 Inch
Vehicle Fitment:
2007 - 2017 Jeep Wrangler Rubicon
2007 - 2017 Jeep Wrangler Sahara
2007 - 2010 Jeep Wrangler X
2010 - 2017 Jeep Wrangler Sport
2011 - 2011 Jeep Wrangler 70th Anniversary
2016 - 2016 Jeep Wrangler 75th Anniversary
2016 - 2016 Jeep Wrangler Sport S
2018 - 2018 Jeep Wrangler JK Rubicon
2018 - 2018 Jeep Wrangler JK Sahara
2018 - 2018 Jeep Wrangler JK Sport
