Motobilt now offers the Jeep JL Hammer front bumper with Fog Light Holes. It features built in provisions for factory style fog lights. The Motobilt Jeep JL Front Hammer Bumper is a 48.5 inch wide, sleek, tight-fitting design proudly made in the USA. Our JL Hammer Bumper is 3D CAD designed to ensure the best possible fit to your Jeep JL. The bumper will fit all 2018 and newer models of the Jeep JL 2 door and 4 door JL Unlimited. The front d-ring mounts are CNC cut from 3/4 inch thick steel plate and pass through the bumper where they weld to the bumper mounting plates in addition to the bumper body. This was done for added strength to the recovery point.
The Hammer bumper has provisions to mount the factory fog lights or aftermarket LED fog lights. We have pre-installed riv nuts for 10-24 screws in the factory bolt pattern. The Hammer bumper can be run with or without the optional skid plate. The ends of the Hammer bumper taper up for tire clearance. Each cut in the bumper was intentional to keep it tight to the frame rail for a better approach angle. The main construction of the bumper is fabricated from 3/16 inch thick high strength steel plate. The bumper also serves as a winch mount. The top side of the JK The Hammer Bumper has bolt holes for a recovery winch.
Features:
Jeep The Hammer 48.5 inch front bumper
Fits 2018 and newer Jeep JL 2 door and 4 door JL Unlimited
Fabricated from 3/16 inch thick high strength steel plate
Bolt on design
3/4 inch thick steel d-ring mounts
Pass through d-ring mounts weld to the bumper
Included Fog Light Holes
Pre-installed riv nuts for 10-24 screws for the factory fog lights
Made in the USA
Sold as each
Note:
If installing a winch, MB1002 fairlead mount will also need to purchased. See Related Parts.
Motobilt bumpers ship bare steel, paint or powdercoat needed before use.
You must fully install BEFORE painting and then removed for paint or powder coating.
No cutting required on the frame rails on your Jeep JL
Skid plate sold separately. See Related Parts.
LED fog light NOT included, but sold separately. See Related Parts
Your factory frame holes may need to be opened up to 5/8” due to tolerance differences in the factory frame rails.
Specs:
Finish:
Bare
Hardware Included:
Yes
Location:
Front
Material:
Steel
Series:
Hammer
Sold As:
Each
Thickness:
3/16 Inch
Vehicle Fitment:
2018 - 2020 Jeep Wrangler Rubicon
2018 - 2020 Jeep Wrangler Sport
2018 - 2020 Jeep Wrangler Sport S
2018 - 2020 Jeep Wrangler Unlimited Rubicon
2018 - 2020 Jeep Wrangler Unlimited Sahara
2018 - 2020 Jeep Wrangler Unlimited Sport
2018 - 2020 Jeep Wrangler Unlimited Sport S
2019 - 2020 Jeep Wrangler Unlimited Moab
2020 - 2020 Jeep Gladiator
